| ALIGNMENT TYPE | RIGID |
| BLOCK TYPE | FIXED |
| BORE DIAMETER | 0.2495 INCHES MINIMUM AND 0.2500 INCHES MAXIMUM |
| CENTER TO CENTER DISTANCE BETWEEN MOUNTING HOLES ALONG WIDTH | 1.055 INCHES MINIMUM AND 1.057 INCHES MAXIMUM |
| HEIGHT FROM BOTTOM OF BASE TO BORE CENTERLINE | 1.830 INCHES NOMINAL |
| HOUSING HEIGHT | 2.335 INCHES NOMINAL |
| INTERNAL FIT-UP DESIGNATION | LOOSE |
| LOAD CAPABILITY TYPE | RADIAL |
| LUBRICATION MATERIAL | GREASE |
| LUBRICATION MATERIAL DOCUMENT AND CLASSIFICATION | MIL-G-81322 MIL SPEC SINGLE MATERIAL RESPONSE |
| OVERALL OUTSIDE DIAMETER | 2.075 INCHES NOMINAL |
| MATERIAL DOCUMENT AND CLASSIFICATION | 66 FED STD ALL MATERIAL RESPONSES BALL |
| MATERIAL DOCUMENT AND CLASSIFICATION | 66 FED STD SINGLE MATERIAL RESPONSE INNER RACE |
| MATERIAL DOCUMENT AND CLASSIFICATION | 66 FED STD SINGLE MATERIAL RESPONSE OUTER RING |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 3652 ASSN STD 1ST MATERIAL RESPONSE OR AMS 3666 ASSN STD 2ND MATERIAL RESPONSE SEAL |
| MATERIAL DOCUMENT AND CLASSIFICATION | AMS 5659 ASSN STD SINGLE MATERIAL RESPONSE HOUSING |
| MATERIAL | STEEL COMP E51100 OR STEEL COMP E52100 BALL |
| MATERIAL | STEEL COMP E52100 INNER RACE |
| MATERIAL | STEEL COMP E52100 OUTER RING |
| MATERIAL | STEEL COMP XM-12 HOUSING |
| MATERIAL | STEEL CORROSION RESISTING AND PLASTIC POLYTETRAFLUOROETHYLENE OR STEEL CORROSION RESISTING AND GLASS FIBER AND PLASTIC POLYTETRAFLUOROETHYLENE SEAL |
| MOUNTING HOLE TYPE | ROUND, THREADED |
| NOMINAL THREAD SIZE | 0.250 INCHES |
| SPECIAL FEATURES | 2ND MTG HOLE 15/16-24UNF 3B |
| ROTATING ELEMENT LOCKING METHOD | STRAIGHT SLEEVE |
| SEAL LOCATION | BOTH ENDS |
| SEAL TYPE | CONTACT |
| SHAFT END TYPE | OPEN |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE INNER RACE |
| SURFACE TREATMENT DOCUMENT AND CLASSIFICATION | QQ-P-416,TYPE 1,CLASS 2 FED SPEC SINGLE TREATMENT RESPONSE OUTER RING |
| SURFACE TREATMENT | CADMIUM INNER RACE |
| SURFACE TREATMENT | CADMIUM OUTER RING |
| TEST DATA DOCUMENT | 97499-BPS 4075 SPECIFICATION (INCLUDES ENGINEERING TYPE BULLETINS, BROCHURES,ETC., THAT REFLECT SPECIFICATION TYPE DATA IN SPECIFICATION FORMAT; EXCLUDES COMMERCIAL CATALOGS, INDUSTRY DIRECTORIES, AND SIMILAR TRADE PUBLICATIONS, REFLECTING GENERAL TYPE DATA ON CERTAIN ENVIRONMENTAL AND PERFORMANCE REQUIREMENTS AND TEST CONDITIONS THAT ARE SHOWN AS "TYPICAL", "AVERAGE", "NOMINAL", ETC.). |
| THREAD QUANTITY PER INCH | 28 |
| THREAD SERIES DESIGNATOR | UNF |